For Architects & Specifiers

Your design.
Cast as drawn.

A sketch, a dimensioned drawing or a reference image comes into our Sapanca workshop and leaves as cast relief. We model it in 3D, make a mould master (3D-printed or CNC-machined, depending on the geometry), take a silicone mould off the master and cast the panel in Lumina PMAG™.

A cast relief panel held above the white silicone mould it was cast from, on the workshop table
Silicone mould and the panel cast from it. Sapanca workshop.
Specification Data

The values that go in your spec.

General product data. Project-specific values go into the project’s technical data sheet.

Project

Composition
Polymer-modified composite gypsum, over 95% mineral by mass
Finish
Paint-ready
Documents
Technical data sheet and installation drawing for every project
Delivery terms
EXW Sapanca by default
Installation
Quoted separately, per project
Specification Support

The surface you approve is the surface we cast.

  1. 01

    Drawing

    We turn your drawing into a 3D relief model. Changes at this stage are made on screen, so they cost nothing in moulds or material.

  2. 02

    Approval under raking light

    Before casting, we read the model under low-angle raking light and send you the images. Nothing is cast until you approve them.

  3. 03

    Master approval

    We make the master from the approved model and put it to you for approval before the mould is taken.

  4. 04

    Documents

    A technical data sheet and an installation drawing, prepared for the project. We agree the specification clauses with your office.

See the process step by step
Materials

One master, one material.

The relief is held in one digital master. The same motif runs from wall panel to column wrap, all cast in Lumina PMAG™. Because the silicone mould flexes, it releases undercuts in the master that a rigid mould would lock in.

Lumina PMAG™

Wall panels, column wraps, counter and desk fronts, accent surfaces and corridor surfaces.

Surface

Paint-ready
The panel leaves the workshop primed; colour and sheen follow the project’s own paint specification and are applied on site.
In the Workshop

Every stage under one roof.

From mould master to crating, every stage happens in our Sapanca workshop.

  1. 01Mould masters, 3D-printed or CNC-machined
  2. 02Silicone mould making
  3. 03Hand casting in silicone moulds
  4. 04Priming and crating
The Sample Box

Judge the surface in your own light.

Check the relief, the surface and the colour under your own lighting rather than on a screen. We send the box to practices with a live project.

Request a sample for your project
Studio Luminant